After Rules ----------- .. NOTE:: All rules in this group are disabled by default. Use a configuration to enable them. after_001 ######### This rule checks for **after x** in signal assignments in clock processes. **Violation** .. code-block:: vhdl clk_proc : process(clock, reset) is begin if (reset = '1') then a <= '0'; b <= '1'; elsif (clock'event and clock = '1') then a <= d; b <= c; end if; end process clk_proc; **Fix** .. code-block:: vhdl clk_proc : process(clock, reset) is begin if (reset = '1') then a <= '0'; b <= '1'; elsif (clock'event and clock = '1') then a <= d after 1 ns; b <= c after 1 ns; end if; end process clk_proc; .. NOTE:: This rule has two configurable items: * magnitude * units The **magnitude** is the number of units. Default is *1*. The **units** is a valid time unit: ms, us, ns, ps etc... Default is *ns*. after_002 ######### This rule checks the *after* keywords are aligned in a clock process. Refer to the section `Configuring Keyword Alignment Rules `_ for information on changing the configurations. **Violation** .. code-block:: vhdl clk_proc : process(clock, reset) is begin if (reset = '1') then a <= '0'; b <= '1'; elsif (clock'event and clock = '1') then a <= d after 1 ns; b <= c after 1 ns; end if; end process clk_proc; **Fix** .. code-block:: vhdl clk_proc : process(clock, reset) is begin if (reset = '1') then a <= '0'; b <= '1'; elsif (clock'event and clock = '1') then a <= d after 1 ns; b <= c after 1 ns; end if; end process clk_proc; after_003 ######### This rule checks the *after* keywords do not exist in the reset portion of a clock process. **Violation** .. code-block:: vhdl clk_proc : process(clock, reset) is begin if (reset = '1') then a <= '0' after 1 ns; b <= '1' after 1 ns; elsif (clock'event and clock = '1') then a <= d after 1 ns; b <= c after 1 ns; end if; end process clk_proc; **Fix** .. code-block:: vhdl clk_proc : process(clock, reset) is begin if (reset = '1') then a <= '0'; b <= '1'; elsif (clock'event and clock = '1') then a <= d after 1 ns; b <= c after 1 ns; end if; end process clk_proc;