Sequential Rules ---------------- sequential_001 ############## This rule checks the indent of sequential statements. **Violation** .. code-block:: vhdl begin wr_en <= '1'; rd_en <= '0'; **Fix** .. code-block:: vhdl begin wr_en <= '1'; rd_en <= '0'; sequential_002 ############## This rule checks for a single space after the **<=** operator. **Violation** .. code-block:: vhdl wr_en <= '1'; rd_en <='0'; **Fix** .. code-block:: vhdl wr_en <= '1'; rd_en <= '0'; sequential_003 ############## This rule checks for at least a single space before the **<=** operator. **Violation** .. code-block:: vhdl wr_en<= '1'; rd_en <= '0'; **Fix** .. code-block:: vhdl wr_en <= '1'; rd_en <= '0'; sequential_004 ############## This rule checks the alignment of multiline sequential statements. **Violation** .. code-block:: vhdl overflow <= wr_en and rd_en; **Fix** .. code-block:: vhdl overflow <= wr_en and rd_en; sequential_005 ############## This rule checks the alignment of the **<=** operators over consecutive sequential lines. Following extra configurations are supported: * :code:`if_control_statements_end_group`, * :code:`case_control_statements_end_group`. Refer to the section `Configuring Keyword Alignment Rules `_ for information on changing the configurations. **Violation** .. code-block:: vhdl wr_en <= '1'; rd_en <= '0'; **Fix** .. code-block:: vhdl wr_en <= '1'; rd_en <= '0'; sequential_006 ############## This rule checks for comments within multiline sequential statements. **Violation** .. code-block:: vhdl overflow <= wr_en and -- rd_address(0) rd_en; **Fix** .. code-block:: vhdl overflow <= wr_en and rd_en;