# Embedded defaults. Copy to config.toml to customize; partial overrides work. # Frequencies here and in CSV are MHz; commands sent to tinySA use Hz. port = "" baudrate = 115200 start_frequency = 240 stop_frequency = 800 points = 10001 repeat = 1 [connection] backend = "serial" # Numeric socket address only; used by the TCP bridge/mock, not by native tinySA USB. tcp_address = "127.0.0.1:7355" tcp_timeout_ms = 3000 [serial] # Timeout for each blocking serial read, not a whole-scan deadline. timeout_ms = 3000 command_delay_ms = 20 settle_delay_ms = 200 scan_delay_ms = 2000 max_response_bytes = 65536 baudrates = [19200, 38400, 57600, 115200, 230400, 460800, 921600, 1843200, 2000000, 3000000] preferred_ports = ["/dev/ttyACM0", "COM3", "COM5", "/dev/ttyS16"] [scan] # Detect Basic versus Ultra from version/info and apply the corresponding scan # profile. `basic` or `ultra` can require (but never fake) an expected family. device_model = "auto" # Permit a detected ZS406 to enter Ultra mode for analyzer scans above its # 900 MHz normal-mode ceiling, up to 5.4 GHz. This changes instrument state and # acknowledges Ultra-mode alias/spur/LO-leakage limitations; it never enables RF output. enable_ultra_mode = false # Select the detected model's native scanraw bias: Basic 128, Ultra 174. auto_zero_offset = true # Manual fallback used only when auto_zero_offset is false. The selected value # is sent with `zero`; the decoder must use that same value. zero_offset = 128 frequency_step_mhz = 10 points_step = 100 min_points = 101 max_points = 1000001 max_repeat = 1000 # Match scanraw's integer-truncated span / points mapping. Use `inclusive` only # to reproduce CSV files created by older tiny-wb releases. frequency_axis = "firmware" # Retain the historical preparatory text scan until hardware confirms removal. legacy_pre_scan = true [ui] poll_interval_ms = 16 chart_min_dbm = -128.0 chart_max_dbm = 0.0 [ui.bindings] # Plot navigation. Values are single characters or left/right/home. zoom_in = ["+", "="] zoom_out = ["-"] pan_left = ["left", "h"] pan_right = ["right", "l"] reset_view = ["0", "home"] [output] directory = "." filename_prefix = "scan" include_header = false [logging] filter = "info" directory = "."